You have no items in your shopping cart.

Subtotal: £0.00

IMAGE

More Views

EVERBUILD 405 PATH & PATIO SEAL NATURAL STONE CONCRETE BLOCK PAVING

Be the first to review this product

Availability: In stock

£17.50

* Required Fields

£17.50

Details

EVERBUILD PATH AND PATIO SEALER is a solvent free acrylic coating used to seal and protect patios, paths, natural stone, concrete and  block paving from the effects of the sunlight, water, oil, petrol and fungal/moss growth. The milky solution dries to hard wearing water repellent film which gives a low sheen slip resistant finish which will reduce dirt pickup and facilitate easier cleaning. The product is safer to use than conventional solvent based products, i.e. it is non- flammable and will not harm plants and animals when used as directed.

 

Benefits

 

  • Solvent free formulation – non-flammable, low odour.
  • Improves appearance of dull paths/stone.
  • Also acts as a dustproofer and facilitates easier cleaning.
  • Dramatically improves water and mar resistance - High degree of water repellency in dried film.
  • Contains a powerful fungicide – prevents unsightly mould growth.

 

Areas For Use

 

  • Seals and protects, paths, patios, natural stone, concrete and  block paving from the effects of the sunlight, water, oil, petrol and fungal/moss growth.

 

Surface Preparation

 

Surfaces must be free from grease, dust, loose material, algae etc.  Clean surfaces with EVERBUILD MOSS AWAY. For bad oil stains, use a proprietary detergent and hot water. For very badly soiled surfaces, use EVERBUILD BRICK AND PATIO CLEANER.  In all cases, wash down the cleaned surface with a hose and broom to remove all traces of cleaning product. All artificial stone (cement based) and all block pavers must be left for three months minimum after placing before over coating with this product. This will allow salts to leach out which otherwise may cause unsightly white patches appearing beneath the sealer, especially when the patio is wet.

 

Application

 

Stir well before use. May be applied to damp (but not wet) surfaces. Apply using a long pile roller and tray or low-pressure spray. Ensure even and thorough coverage, especially on textured finishes where ponding of the material must be avoided. Apply in two coats, allowing 2 hours between coats. An extra coat may be applied if a semi gloss finish is required. Drying time will be 4 hours from last coat at 20oC. This will be extended at lower temperatures. Do not apply below 5oC.

 

Areas treated with this product can be cleaned with warm water and detergent or EVERBUILD MOSS AWAY. Do not use acid based cleaners, as these will remove/discolour the product. Avoid using power washes.

 

Specific Data

 

 

Appearance

Clear solution (water based)

Specific Gravity @ 20°C

1.05 g/cm³

M.F.F.T

5°C

Solids

16% w/w

Drying Time

4 hours

Coverage

1 Litre will cover approximately 8m² per coat depending on nature of surface

 

 

Health & Safety

 

Consult MSDS for full list of hazards.

 

Storage

 

Store at moderate temperatures in original containers. PROTECT FROM FROST.

 

Shelf Life

 

12 months when stored according to manufacturer’s instructions.

 

Additional Information

COLOUR COLOUR

Customer Reviews

Write Your Own Review

You're reviewing: EVERBUILD 405 PATH & PATIO SEAL NATURAL STONE CONCRETE BLOCK PAVING

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Brands

  • brand
  • brand
  • brand
  • brand
  • brand
  • brand