You have no items in your shopping cart.
Details
A high viscosity ethyl cyanoacrylate adhesive with gap filling properties.
HVC16 combines high tensile strength with improved impact resistance resulting in a toughened bond. HVC16 higher viscosity enables it to be used on porous and vertical surfaces without excessive penetration or running.
Uses
Bond It HVC16 SUPERGLUE can be used for bonding:
- PVCu trims
- rubbers
- timbers
- many plastics
The high viscosity is particularly suitable for use with foam products.
Preparation
Surfaces to be bonded must be clean, dry and free from dust, grease, oil or any other contaminants that may hinder adhesion.
Application
HVC16 permits readjustment of components before bonding commences. Apply a thin film to one side only and bring together immediately. Reposition within 2-3 seconds. Maintain light pressure without movement of joint for at least 10 seconds, do not handle until bonding time stated above has expired. Clamp or hold for a few seconds. As the polymerisation of cyanoacrylates is initiated by moisture from the atmosphere best results will be obtained if the relative humidity is in excess of 50%. Higher levels of humidity reduce the opportunity for monomer evaporation thus limiting fume build up. If bonding is continuous process good ventilation must be ensured.
Storage Conditions
Store in a closed upright container between 20 and 25oC in dry dark conditions. Uncapped containers will absorb moisture from the air and will deteriorate in performance rapidly. At low temperatures the shelf life will be prolonged (see below).
Shelf Life
Stored at 5oC shelf life will be up to 12 months.
Stored between 20 and 25oC shelf life will be reduced to 6 months.
-------------------------------------------------------------------
RGC24 Medium Viscosity Adhesive
Description
An economic, medium viscosity, ethyl cyanoacrylate adhesive.
RGC24 is a rapid curing adhesive specially formulated to give good adhesion to most rubbers and plastics. Good humidity resistance of cured adhesive. Excellent adhesion to EPDM & SBR rubbers.
Uses
Bond It RGC24 SUPERGLUE can be used for bonding:
- synthetic rubber gaskets in glazing systems.
- assembly of rubber bush systems.
- timbers.
- many plastics.
Application
All surfaces must be clean, dry and grease free. Apply adhesive to one surface only. Bring components together immediately. ALIGN PERFECTLY – Once joined components cannot be repositioned. Maintain light pressure without movement of joint for at least 5 seconds, do not handle until bonding time stated above has expired. As the polymerisation of cyanoacrylates is initiated by moisture from the atmosphere best results will be obtained if the relative humidity is in excess of 50%. Higher levels of humidity reduce the opportunity for monomer evaporation thus limiting fume build up. If bonding is continuous process good ventilation must be ensured.
Bonding Times
Ambient conditions - room temperature 20°C/ 60% RH:
Plastics 5-30 seconds
Rubbers 1-15 seconds
Storage Conditions
Store in a closed upright container between 20 and 25oC in dry dark conditions. Uncapped containers will absorb moisture from the air and will deteriorate in performance rapidly. At low temperatures the shelf life will be prolonged (see below).
Shelf Life
Stored at 5oC shelf life will be up to 12 months.
Stored between 20 and 25oC shelf life will be reduced to 6 months.
Additional Information
COLOUR | COLOUR |
---|