You have no items in your shopping cart.

Subtotal: £0.00

IMAGE

More Views

BOND-IT ANCHOR BOND CHEMICAL STUDDING POLYESTER RESIN MORTAR ANCHORING SYSTEM

Be the first to review this product

Availability: In stock

£7.09

* Required Fields

£7.09

Details

A polyester resin, 2-part, rapid curing, chemical anchoring system. Applied in one single action to produce a cost effective, tough chemical resistant fixing.

Uses

Suitable for setting bolts, studs, wall ties, starter bars or large screws, etc into a wide range of substrates. Compatible with brickwork, concrete, masonry, stone and PFA blocks. Hollow base materials can also be securely fastened using ANCHOR BOND in conjunction with a sleeve or sieve. Chemically resistant, waterproof and vibration proof..

Preparation

Drill a hole to the correct diameter and depth, ideally using a rotary percussion machine. For optimum results the wall sides should be thoroughly roughened. Clean hole and remove all dust and debris using a hand air pump or a stiff rotary brush, if required.

All bars should be clean and free from oil or grease and all flaking rust should be removed. Threaded rods or studs should be chisel ended to prevent them being unscrewed from the cured resin.

Application

Screw the mixing nozzle on to the cartridge (hand tighten). Place the ANCHOR BOND cartridge into the dispensing gun. Squeeze the hand trigger a few times until material passes through the mixing nozzle. Allow the material to flow until an even colour is obtained (normally 5-6 inches). Insert the nozzle into the base of the hole and extrude material, half filling the hole with resin. Withdraw the nozzle then insert the fixing into the filled hole, slowly rotating to fully coat the surface. After application release the pressure from the dispensing gun. Remove the used mixing nozzle and wipe away excess material from the end of the cartridge. Once the resin has cured the fixture can be attached to the fixing and fully tightened. Do not over pressurise cartridge otherwise leakage may occur from rear pistons.

 

 

Container Size

310ml and 380ml plastic cartridges.

Shelf Life

12 months.

Storage Conditions

Store in a dry area between 5oC and 25oC. Keep out of direct sunlight. Storage at higher temperatures will reduce the shelf life.

Additional Information

COLOUR COLOUR

Customer Reviews

Write Your Own Review

You're reviewing: BOND-IT ANCHOR BOND CHEMICAL STUDDING POLYESTER RESIN MORTAR ANCHORING SYSTEM

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Brands

  • brand
  • brand
  • brand
  • brand
  • brand
  • brand